微凍式氧氣晾干機
◆護膚品結構特征 Product features
空調制熱及室內空氣系統,經專家組最準算出,規劃數據均留20%及以上的剩余。冷庫縮減機選取縮放式或渦旋式式、活塞環式全半開敞冷庫縮減機及半半開敞螺絲桿式冷庫縮減機(20HP上面),進行穩固,躁音低,耐熱性可信度,費電生存期長。能耗比好,防范游戲等級為IP54(防污及防濺)
熱更換器、風冷卻水器所采用優越無縫鋼管帶純鋁鰭片,攏流設計傳熱產出率好、故而體型大小小,設計狹窄。封頭材質所采用不銹鋼或冷軋鋼鍍鋅板,可盡量避免對降低水汽的2次破壞。制冰操縱器件能力優異。具熱電廠擴張閥的節流穩壓基本作用,熱風旁通閥的能量轉換調高基本作用,過電流值、過電動機扭矩、制冷劑高壓低壓呵護等基本作用。
汽液離心轉移法出來器選用風暴離心轉移法出來與不銹材料網捕霧生物碳切合,包括汽液離心轉移法出來實際功能恢復原狀,禁止水分的重新揮發,保證冷干機的低溫干燥實際功能。它比風暴離心轉移法出來器性好,同樣又比濾過式汽液離心轉移法出來器運行成體低,包括性價錢比。水冷凝劑器為優秀低翅鋼管,慢水流量、多沖程,傳熱錯誤率好,短期運行不適宜水垢。重新排出污水器按需設施,除水加環保節能,實際功能好;浮球式,手機定時任務待選擇。外電機轉子冷排風扇,辛苦量、低噪音污染,不停開關長人類壽命。
抗壓配件機器組成設計方案合理的,方便于維護護膚;表面上熱噴塑,外觀形狀牢固,不腐蝕生銹;無基礎知識按裝,程序加載穩定無機械振動,返修率低,無使用量品,程序加載保險費用少,連續不斷程序加載不必妥善為你守候。
Refrigeration and air system, the experts accurate calculation, design parameters are left more than 20% of the surplus. Refrigeration compressors adopt international advanced rotary or scroll type, piston enclosed refrigeration compressor and close partly screw refrigeration compressor (20 HP above), stable operation, low noise, reliable performance, save electricity long life. Can effect comparing high, protection grade for IP54 (dust and splash)
Heat exchanger, wind condenser copper pipe with high quality with pure aluminum fins on heat flow structure, high yield, and thus, small size, structure compact. The cylinder body materials selecting stainless steel or carbon steel galvanized, can avoid to compressed air of the secondary pollution. Refrigeration control elements adopt the most advanced Denmark danfoss (DANROSS) and the Persian LAN (SPORLAN), (ALCO) refrigeration components, excellent performance. Thermal expansion valve with the throttling step-down function, heat the by-pass energy adjustment function, over electric current, the load, cold media high voltage protection.
Liquid-vapor separator using whirlwind separation and stainless steel wire the organic combination of the trap with gas liquid separation effect of moisture, avoid completely secondary evaporation, ensure the blotting etc.is dry effect. It than cyclone separator performance is good, at the same time than a gas-liquid separator filter brand-newly type use adult, and has a low price is high performance. Water condenser copper pipe for high quality, low wing, stroke, slow flow in high thermal efficiency, use for a long time shoulds not be scaled. Automatic drainage device according to the needs, in addition to water and energy saving set, the effect is good; Float type, electronic timing can choose.The cold wind, big rotor fan air, low noise, long life. Stop frequent rev.
Parts are confined by national gb1501998 "steel pressure vessel" and GB151-1999 "tubular heat exchanger of manufacture, test and check and accept," pressure vessel safety technology supervision code "supervision. Equipment structure design is reasonable, facilitate maintenance; The surface heat spraying, beautiful appearance, not rust; No basis installation, smooth operation no vibration, maintenance rate is low, no consumables, operation cost less, without waiting for continuous operation special.
工作狀況狀況與技術水平因素 Working condition and technical indexes | |
進氣水溫 The inlet temperature |
常溫下型≤50℃,高溫環境型≤80℃ |
蒸發模式 Cooling way |
風冷(風冷) |
區域溫度因素 Environment temperature |
≤40℃(風冷) |
壓差露點 Pressure dew point |
1.7℃~10℃(0.7 MPa) |
冷暖空調劑 Refrigerants |
R-22或結合客人必須可選用R134a,R404 a,R507等無氟環保型冷暖空調劑。 |
進氣壓為 The inlet pressure |
0.2~1.0MPa(6.4 MPa以下的展開進貨) |
壓為盤虧 The pressure loss |
≤0.02 MPa |
放置循環水系統水進室溫 Cooling water inlet water temperature |
≤32℃(油冷) |
蒸發水入水壓 Cooling water feed water pressure |
0.15~0.4 MPa(水冷式) |
◆主要的高技術產品參數 Main technical parameters
ADH |
-5F |
-10F |
-20F |
-30F |
-60F |
-75F |
-120F |
-150F |
-200F |
-250F |
-300F |
-400F | |
凈化生產量 Capacity m3/min |
0.7 |
1.6 |
2.6 |
3.8 |
7.0 |
8.5 |
13.5 |
17 |
23 |
27 |
34 |
45 | |
上班壓力差 Work pressure |
| ||||||||||||
露點室溫 Dew point temperature |
| ||||||||||||
制冷空調劑 Refrigerants |
R-12 |
| |||||||||||
外接電源 Power |
|
| |||||||||||
再風機工作電壓 Compressor power(KW) |
0.18 |
0.28 |
0.6 |
0.75 |
1.1 |
1.3 |
2.2 |
2.9 |
3.7 |
4.8 |
5.5 |
7.5 | |
散熱風扇主軸電機功效 Fan motor power(W) |
30 |
170 |
170 |
180 |
300 |
300 |
510 |
510 |
600 |
720 |
900 |
1200 | |
接頭長寬 Interface size |
ZG1/2" |
ZG1" |
ZG1" |
ZG1.5" |
ZG1.5" |
ZG2" |
DN80FL |
DN80FL |
DN80FL |
DN80FL |
DN80FL |
DN80FL | |
自己的外觀尺寸大小 Appearance and size |
長L(mm) |
530 |
800 |
800 |
800 |
1100 |
1100 |
1550 |
1400 |
1550 |
1800 |
1900 |
2000 |
寬W(mm) |
360 |
450 |
450 |
450 |
600 |
600 |
650 |
780 |
780 |
780 |
950 |
950 | |
高H(mm) |
490 |
970 |
970 |
970 |
1250 |
1250 |
1480 |
1580 |
1580 |
1580 |
1800 |
1800 | |
凈重量 Weight(kg) |
50 |
95 |
100 |
100 |
210 |
250 |
350 |
470 |
550 |
650 |
800 |
1000 |